AIRBAG CONTROL UNIT VINYL COVER INSTALLATION AND SIDE AIRBAG CONNECTOR CLIP REPLACEMENT (CAMPAIGN 088)


IMPORTANT: DEALERS MUST PERFORM THIS CAMPAIGN ON ALL =
AFFECTED 
VEHICLES WHENEVER AN AFFECTED VEHICLE IS IN THE SHOP 
FOR ANY MAINTENANCE OR REPAIR. 
IMPORTANT: WHEN A VEHICLE ARRIVES AT THE SERVICE =
DEPARTMENT, 
ACCESS HYUNDAI MOTOR AMERICA’S “WARRANTY VEHICLE 
INFORMATION” SCREEN VIA WEBDCS TO IDENTIFY OPEN 
CAMPAIGNS. 
DESCRIPTION: 


This bulletin describes the repair procedures for two =
conditions=20
that lead to airbag 
warning light illumination. 
Production Date: June 30, 2000 through April 26, 2001 =
(Labor=20
Operation 81B026R0) 
Includes following: 
=95 Side Airbag Wiring Connector Clip Replacement and =
Wiring=20
Attachment Revision 
=95 Airbag Control Module Vinyl Cover Installation 
Production Date: April 27, 2001 through December 18, =
2001 (Labor=20
Operation 
81B026R1) 
Includes following: 
=95 Side Airbag Wiring Connector Clip Replacement and =
Wiring=20
Attachment Revision 


Airbag Control Module Vinyl Cover Installation: =
If a drink is spilled in the area of the 
cupholder on the center console, the liquid may seep =
through the=20
console opening for 
the parking brake lever and drip onto the airbag control =
module=20
connector that is located 
under the center console. If the airbag control module =
is=20
contaminated, it will result in 
airbag warning light illumination. This bulletin =
provides the=20
procedure to install a 
protective cover over the airbag control module wiring =
connector=20
to protect the module 
from unintentional liquid spills. 

face=3DArial>
Side Airbag Wiring Connector Clip Replacement & =
Wiring=20
Attachment Revision: 


A side impact airbag wiring harness is mounted under =
each front=20
seat. If that wiring 
harness experiences movement, possibly caused by contact =
from=20
materials placed 
under the seat, it may result in an electrical =
resistance that=20
would result in airbag 
warning light illumination. This bulletin provides the =
procedure=20
to replace the side 
impact airbag wiring harness connector clips and revised =
wiring=20
harness attachments 
under the driver’s and front passenger’s =
seats. 


NOTE: Before conducting the appropriate repair =
procedure, verify=20
the vehicle 
falls within the production date range as noted =
above. 
Airbag Control Module Vinyl Cover Installation (June 30, =
2000=20
through 
April 26, 2001): 

Posted in Service Campaign.